On Tuesday we discussed with Graham to check that we were on schedule for this project. Me and Paul then ordered what we could find from the EMA catalogue for our final model but we could not find more suitable tubing in the correct width in and material that would heat bend than what we already have. Me and Angel then cut out the railing supports and drenneled in the tiny holes while Paul constructed the base board. We decided to make the baseboard roughly square to the size of an A3 page with enough space underneath so that the model can be attached to the centre with a bolt.Today we completed the sketch model with a wooden walkway and wire railings. We decided that we prefer the look of this railing to laser cut acrylic so we will reproduce this in the final model. I have been sand sealing, filling and priming the base board.
No comments:
Post a Comment